Below Grade Foundation Coating
Del-Val 400
Non-Fibered Foundation Coating
Description
Del-Val 400 Non-Fibered Foundation Coating is a non-fibered asphalt coating that is used to prevent moisture penetration through foundation wall surfaces. After Del-Val 400 Non-Fibered Foundation Coating is applied it forms a smooth, flexible shell that helps resist the entrance of moisture through foundation walls.
Prevents moisture penetration through Foundation wall surfaces with a smooth, non-fibered, flexible shell.
Quick Application Guide
D449-83
Coverage Rate
1–1½ GAL
Per Square (Per Coat)
Uses
Del-Val 400 Non-Fibered Foundation Coating is used for exterior, below grade masonry and block walls where no hydrostatic pressure is present.
Preparation
All surfaces must be clean and free of any oil, grease, dirt and all other foreign matter. Must stir coating before using.
Application
Can be applied using: brush, roller or heavy duty spray equipment. Allow 24 hours drying time before backfilling against the foundation walls. Do not apply over wet/damp or frost covered surfaces.
Coverage
Apply at the rate of approximately 1 to 1.5 gallons per 100 sq. ft.
Cleanup Del-Val 400 Non-Fibered Foundation Coating
Clean tools with Del-Val Orange Cleaner & Degreaser or mineral spirits, taking necessary precautions when handling combustible liquids.
Precaution
DO NOT THIN. DO NOT HEAT CONTAINER. DO NOT store in an area where temperatures exceed 120˚F
Code Approvals / Compliance
This product meets or exceeds the requirements of ASTM D449-83 Type I & ASTM D-4479 Type I.
Product Information
Sizes Available
Tools Needed
DATA SHEETS
Available From These Distributors
Click a logo to find a location close to you.
Have Additional Questions About Del-Val 400 Non-Fibered Foundation Coating?
Have a product specialist reach out to answer any questions you may have.
Please fill out the below form completely and we’ll be happy to get in touch with you!