Flexible Water-Based Vapor Barrier
Del-Val 412
Polymer Modified Foundation Emulsion
Modified with polymer to increase flexibility, Creates a breathable vapor barrier & Meets ASTM.
Description
Del-Val 412 Polymer Modified Foundation Emulsion is a specially refined clay stabilized asphalt-emulsion modified with polymer to increase flexibility. Del-Val 412 Polymer Modified Foundation Emulsion provides a superior vapor barrier and excellent dampproofing & waterproofing protection. When applied the surface is breathable permitting water vapor to escape while curing, which allows for application over “green” or damp surfaces and helping to prevent blistering. The dried film surface of Del-Val 412 cures to a tough, durable, flexible finish to contend with extreme changes in temperature and vibration. It has a low odor and will not support combustion in the liquid state.
Cures to a tough, durable, flexible finish to contend with extreme changes in temperature & vibration.
Uses
Del-Val 412 Polymer Modified Foundation Emulsion is ideal for reducing dampness and moisture infiltration through foundation walls, parapets, firewalls, tanks, culverts, cisterns, and bridge abutments. Del-Val 412 is applicable for above-grade cavity wall applications and below-grade masonry wall damp proofing and helps to minimize internal structural damage from mildew and mold.
Preparation
Surface should be free of oil, grease, dirt and other materials which would inhibit adhesion. Repair cracks and holes with Del-Val 413 Emulsion Mastic incorporating reinforcing membrane. Surfaces to be coated may be damp but puddled water should be avoided. Dry surfaces may be dampened prior to application.
Application
Can be applied using: brush, roller or heavy duty spray equipment. Allow 24 hours drying time before backfilling against the foundation walls. Do not apply over wet / damp or frost covered surfaces. For best results weather should be clear with no threat of rain for 48 hours.
Coverage
Apply at the rate of approximately 3 –5 gallons per 100 square feet. Coverage will vary depending upon age, dryness and porosity of surface.
Code Approvals / Compliance
This product meets or exceeds the requirements of ASTM D1187, Type II & ASTM D1227, Type III.
Product Information
Sizes Available
Tools Needed
DATA SHEETS
Available From These Distributors
Click a logo to find a location close to you.
Have Additional Questions About Del-Val 412 Polymer Modified Foundation Emulsion?
Have a product specialist reach out to answer any questions you may have.
Please fill out the below form completely and we’ll be happy to get in touch with you!